915 Generation XY-DT01 Digital Temperature Controller -40-110°C Digital -Digital Thermostat with LCD Display and Waterproof Sensor

Simple to UseThe temperature range for this temperature controller is -40-110 Convenient to set and adjust with HD LCD display and 4 ons It is a relay temperature controller you need to connect additional power supply for the load
High Current 30A Relay 220V 30A It is can be used equipment like refrigeratorbrooderincubatorFermenter Greenhouseetc Connect power supply and heatingcooling equipment p the probe and set the temperature it will work great
HeatingCooling Function Heating Mode 'H' when the detection temperature less than set temperature - hysteresis temperature the relay is turned on and the heating equipment starts to work When the detected temperature the set temperature the relay is disconnected and the heating equipment stops working The principle of Cooling Mode 'C' is the same
Delay &Temperature Correction Function Delay 'OPH' When a heating or cooling job is completed the system starts timing 'T' When T OPH the system can the round of heating or cooling work Temperature Correction 'OFE'-100-100 When the system works for a long time there may be deviations which can be corrected by this function Actual temperature = measured temperature calibration value
High Temperature Alarm Function When the actual temperature the alarm temperature the system will turn on the sound and light alarm and disconnect the relay press any on to stop the sound and light

Use Steps
1 Connect sensor to controller
2 Connect to power supply to controller
3 Adjust TemperatureStop temperature and Temperature Correction
4 Remove power supply
5 Connect to load with power supply at relay output terminal if need at Step5 in
6Connect to power supply for controller again
7 Test and working
colorAs shown
Materialplastic

Package Contents
1 x XY-DT01 Digital Temperature Controller

Only the above package content other products are not included
Note Light and different displays may cause the color of the item in the picture a little different from the real thing The measurement allowed error is - 1-3cm