For Toyota Land Cruiser 2010-2019 Car Auto Electronic Accessories Head Up Display HUD Professional

Car Head Up Display:For Toyota Lander Cruiser J200 V82010-2021- Reflecting Car Information On the Windshield -- Safe Driving Screen -Special Notice:Only Fit the car of Left Hand Drive Country.Please don't order for Right Hand Drive Country Buyers .Please check the front speaker's outline to see if our HUD is the same as it before order.Thank you.HUD has 21 features that are impeccable:1.   Multi colour design es the screen easier to read highlight ant details for quick viewing;2. The use of nanotechnology to eliminate unwanted reflections ing the information easier to read;3.  Ability to display a huge range of car statistics including: speed, engine rotational speed, water temperature, battery voltage, instantaneous consumption, average consumption, local time,single driving time,mileage measurement, shift reminder, fatigued driver reminder, low voltage alarm, high temperature alarm, speed alarm, engine fault alarm, fault code elimination, ability to change units e.g. Kilometre/mile4.  Auto power on and off with the vehicle5.  Automatic and manual brightne adjustment mode.It can let us keep ck of all kinds of data on the vehicle dashboard, and can grasp it in real time without looking down, avoiding ffic accidents caused by disction while driving.HUD head-up display for a new driving experienceConcealed Design Deamle FitThe car is designed to be built by the car, highly matched, and directly reps the car.1.Ensure your vehicle is II compatible or EU.1. Check around the area under the steering wheel for an plug2.Contact your vehicle manufacturer or search online3.  Open the bonnet and look for a II compatible sticker (this is NOT on all II compatible cars, therefore isn’t a deciding factor)2.Locate the 16 pin diagnostic link. This is usually located in the area under the steering wheel.3.Start vehicle’s engine and ensure power switch is in the on position.4.HUD will power on with engine1. If the HUD displays vehicle voltage, consumption, speed and rotational speed the unit has installed correctly.2.Failing the above: Wait up to one minute for to sync and confirm cable is plued in properly