66Pcs/Set Car less Dent Removal Kit, Auto- EU Plug

Feature: Not easy to rust,strong hardness, elasticity.
It has a wide range of repair, especially suitable, For the repair of .
Auto Car Dent Removal Damage Repair Puller Lifter
Back Side Repair: (Take repair as an example) 1. Confirm the range of the dent; 2. Remove the Inner ; 3. Select a suitable pen head and install it on the M8 nut port of the arc crowbar; 4. Extend the crowbar into the back of the dent and force the dent out; 5. If there is a bulge, use a suitable pen head and install it on the pen holder; 6. Aim the bulge and hit the pen with a hammer frequently and slightly until the bulge disappears.

Specification:
Steps(2 ways to repair)
1.clean the dent and keep it dry!
2.take out the , and insert it into the , then wait for over 5 minutes.
3.take out a suitable tabs,and smear the on the tabs, quickly on the surface of the dent, and keep on smearing on the surface, until the tabs is covered by the fully, after that, wait for over 10 minutes.
4.Fasten the arc crowbar with the tabs,then adjust the height by screwing handle nut, and use different strength to raise the crowbar to pull the dent out.
5.clean the surface with cleaning tools set.
6.If the surface is convex, knock it slightly with pen and hammer Repeatedly, until the surface is level.
7.if the dent and convex surface are still existent, repeat the steps above, are satisfied with it.
Plug Type:EU Plug,it applies to Indonesia, Germany,France,,Italy and so on.
voltage:AC220V
Material: Metal
colour: As shown

Package Contents:
1 x arc crowbar
1 x M10 screw
1 x M10 nut
1 x M10 Handle Nut
1 x puller adapter
1 x M8 Multi-directional
24 x purple tabs
10 x yellow e sticks
10 x white sticks
1 x (EU car charger Plug)
1 x hammer
1 x pen
9 x pen heads
1 x towel
2 x shovel
1 x bottle( not included)
1 x English manual

Only the above package content, other products are not included.
Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.