Jonsbo M.2-3 Solid State Radiator

Jonsbo M.2-3 Solid State Radiator

1. Material: aluminum
2. Heat dissipation method: drainage pive heat dissipation
3. With high-quality thermal silica , quickly conduct heat to avoid overheating and slowing down
4. Suitable for M.2 2280g solid state drive
5. Anode sand process, anti-corrosion and anti-rust, not easy to get dirty
6. Diversion type upper heat sink, solid state drive (not included)
7. The heat sink under the shell, the overall heat dissipation effect is good
8. Striped lines at the bottom increase the heat dissipation area and quickly take away heat
9. Dimensions: 24.4x7.3x6.9 cm
10. Weight: about 80 grams

installation steps:
1. Tear off the thermal pad film and stick it in the bottom card slot
2. Put the SSD into the card slot with the chip facing up
3. Adjust the of the to reveal the golden fingers and screw holes
4. Stick a thermal pad on the inside of the top fin (tear off the film)
5. After one side of the card slot, press to fix it
6. If you need to disemble, slide your fingernail along the seam to open it
7. Insert the motherboard slot
8. Fix the hard drive screws (included with the motherboard)
9. Installation is complete