RHINOESC 80A-S20 AM32 RC Crawler ESC Brushless Motor Porwer Systm for TRX4 SCX10

RhinoCrawler RM-S12 / RM-S20 is an extremely torque dense and lightweight choice with exceptional startup! It has more mounting positions, beefier wire retainer, and thicker back iron. RM-S12/20 is very difficult to produce, and it is currently the smallest size of the 2812/2820 stator, the outer size of the RM-S12 stator 2812 is only 35x24mm! RM-S12 stator 2820 is only 35x32mmIn addition, it adopts a specially customized dual tile strong magnetic design, which makes the motor lightweight and has stronger explosive power on the basis of small size!

AM32 custom firmware. It's optimized for crawler and makes your car run supers mooth and quiet, but it is also suitable for a variety of 1/8 scale or smaller cars. A built-in adjustable four voltage BEC with a maximum current 10A(VE80A),  3A(VE40A) to apply the high torque servo. In addition, the e-Switch that comes with it avoids failures caused by harsh environments.

AM32 custom firmware

Sinewave startup

allows the motor smoothly at ultra-low speeds Variable drive frequency

Low voltage, throttle

loss and stalled rotor protection

High-performance

32-bit MCU

E-switch with long

life and waterproof

Specs

Product Num.: A3100

Battery: 2-4S/40A, 2~8S/80A

Current: 40/80A cont.

BEC: 40A - max 10A, output

/80A - max 10A, output

5.2~8.2V adjustable by DIP switch

Waterproof: ESC not

supported / e-switch supported

FAN: not include,

solder pads for power is reserved

Connectors: not include

Wires: battery 14AWGx150mm,

output 14AWGx150mm, signal 250mm and e-switch 120mm

Dimensions: 25x13x11mm @40A / 60x29x15mm

@80A

(without wires)

S12 Specs:

KV: 1470KV / 1900KV / 2340KV

14 pole 12 slot stator

8.4V -16.8V (2-4S) LiPo

1/8" D (3.17mm) shaft output

25mm Mounting holes for M3 screws

84g with wires, without connector

35mm diameter x 24mm long

28x12mm stator

S20 Specs:

KV: 1450KV / 1800KV / 2220KV

14 pole 12 slot stator

8.4V -16.8V (2-4S) LiPo

1/8" D (3.17mm) shaft output

25mm Mounting holes for M3 screws

120g with wires, without connector

35mm diameter x 32mm long

28x20mm stator