كابل التكديس لمفاتيح Juniper

Product Overview

The Stack Cable for Juniper Switches is a high-performance Virtual Chassis/stacking interconnect cable designed to link multiple Juniper switches into a single logical unit. It supports reliable high-speed communication between stack members, simplifies management through unified control, and ensures minimal latency and high resiliency in stacked switch deployments.

Technical Specifications

Compatibility

This stacking cable is compatible with a wide range of Juniper switch models supporting Virtual Chassis / stack architectures, including but not limited to:

• Juniper EX4200 series
• Juniper EX4500 / EX4550 series
• Juniper EX4300 / EX3400 series (with rear Virtual Chassis ports) Geizhals+1

Note: Always verify your specific switch model supports the Virtual Chassis/stacking scheme and use the correct cable length and type. Using third-party cables not tested/approved may still work but could affect warranty/support.

Applications

• Stack multiple Juniper switches in a Virtual Chassis configuration to appear as a single logical switch.
• Campus/distribution layer stacking for simplified management and scaling.
• Data center rack deployments requiring high availability and simplified topology.
• Network expansions with minimal cabling complexity between stack members.

Installation Guidelines

• Choose the cable length that allows minimal slack and adequate routing — avoid excessive coiling.
• Connect stack link ports (Virtual Chassis ports) on both switches securely.
• Ensure proper seating of connectors; verify link status/LEDs after connection.
• Avoid sharp bends; maintain bend radius per spec (e.g., 1 in / 2.54 cm minimum for some models) Geizhals
• Use only compatible firmware/software versions supporting Virtual Chassis; check for any compatibility notes.
• For best practice, use cables approved by Juniper for the model in use.