مشاركة هذا المنتج

MG Chenguang fall-resistant correction belt I-CLEAN correct tape - 12M * 5mm - No:ACT76301

58.00 جنيه

2 units left

شحن مجاني الي 6 اكتوبر

0 out of 5

(لا يتوفر تقييم)

شحن مجاني

جاهز للإستلام من ‎٠٧ مايو‎ إلى ‎٠٨ مايو‎ إذا أكملت طلبك خلال ‎4hrs 1mins‎

مصاريف الشحن 20.00 جنيه

جاهز للتوصيل من ‎٠٧ مايو‎ إلى ‎٠٨ مايو‎ إذا أكملت طلبك خلال ‎4hrs 1mins‎

يمكنك إرجاع المنتج مجانًا خلال 14 يوم من الاستلام إذا كان مؤهلًا للإرجاع. يجب الإبلاغ عن أي عيوب ظاهرية خلال 48 ساعة.لمزيد من التفاصيل راجع سياسة الإسترجاع

ELMANAR Store Marketplace

88%تقييم البائع

959 المتابعين

معدل سرعه توصيل الطلب: جيد

تقييم الجودة: ممتاز

تقييم العملاء: جيد

Chenguang fall-resistant correction belt I-CLEAN correct tape - 12M * 5mm - No:ACT76301
Made in China
Made of high quality
3 gear structure/less effort to use, stable and stable to use/more comfortable to use
Place the correction tape head close to the position to be corrected, with the tape surface at an angle of approximately 45 degrees to the paper surface, press lightly and drag the tape surface backward;
At the correction end position, lift it vertically at 90 degrees to cut off the correction tape coating beautifully.
If the belt core is loose, please turn the gear as shown in the figure to adjust the slack
During use, please be careful not to shake or tilt the tip part, which can make the correction more suitable
Put paper or
●During use, please be careful not to shake or tilt the tip part, which can make the correction more suitable.
●Please do not use this product in an S shape to avoid causing
Use other flat items underneath to make corrections smoother.
After use, please replace the protective cap.
The belt becomes slippery.

Chenguang fall-resistant correction belt I-CLEAN correct tape - 12M * 5mm - No:ACT76301
Made in China
Made of high quality
3 gear structure/less effort to use, stable and stable to use/more comfortable to use
Place the correction tape head close to the position to be corrected, with the tape surface at an angle of approximately 45 degrees to the paper surface, press lightly and drag the tape surface backward;
At the correction end position, lift it vertically at 90 degrees to cut off the correction tape coating beautifully.
If the belt core is loose, please turn the gear as shown in the figure to adjust the slack
During use, please be careful not to shake or tilt the tip part, which can make the correction more suitable
Put paper or
●During use, please be careful not to shake or tilt the tip part, which can make the correction more suitable.
●Please do not use this product in an S shape to avoid causing
Use other flat items underneath to make corrections smoother.
After use, please replace the protective cap.
The belt becomes slippery.