Universal Stainless Steel Snap-on Bias Tape Binder Metal Foot For Brother Sewing Machine CUI

Material: Stainless steel

Size: 5.2cm x 2cm/2.0" x 0.8" — Roll hole:3.2cm x 1cm/1.6" x 0.4

Color: Sliver



Features:

It is used to apply pre-folded bias binding tape or bias tape you have cut yourself to the edge of fabric

in one easy step.

It is equipped with a small funnel to fold and guide the binding over the fabric edge before it reaches

the needle and can be used with either zigzag or decorative stitches as well as straight stitch.

10 mm to 14 mm bias tape can be used.

Fit for All Low Shank Singer,Brother,Babylock,Viking (Husky Series),Euro-Pro, Janome,Kenmore,White,

Juki,Bernina (Bernette Series),New Home,Necchi,Elna,etc.













Use Instructions:

1. Before installing the presser foot, turn the trim strip inserted into the guide groove of the presser foot,

trim selvage ensure alignment of the presser foot guide groove;

2. Pull the trim strip from the rear of the presser foot;

3. Install the presser foot;

4. Adjust the needle position, until the needle point is located at the edge trim.

Tip: If you can not adjust the needle to the appropriate location on the trim, you can loosen the presser

foot screw and move around to adjust the position of the guide groove.



Notice

1、Please allow 1-3cm error due to manual measurement.Pls make sure you do not mind before you bid.

2、The color may have different as the difference display,pls understand