Access Control Fingerprint Control Board 7-30V Fingerprint

1.Compatible with voltages in the range of DC7V-30V;
2.Three control modes can be switched: jog mode, self-locking mode, and ignition mode;
3.In jog mode, the output time can be adjusted, and the output can be up to 15 minutes;
4.Relay normally open normally closed contact signal output
5.The relay supports loads with a current of less than 10A

Type:fingerprint control board
Multifunctional fingerprint identification electric lock control module; compatible with DC7-30V voltage;
multiple control modes to meet your needs;
plug-in connection, convenient installation;
suitable for DIY modification, can be used for access control, car control , Electrical control, industrial control and other occasions.
Can be connected to the exit button;
Three control modes:
Inching mode:turn on after fingerprint recognition; automatically turn off after releasing the finger and reaching the set delay time.
Self-locking mode:turn on after recognizing the fingerprint; after releasing the finger, it will be disconnected immediately after re-identifying the fingerprint.
Ignition mode:keep the fingerprint recognition unreleased; it will keep on all the time, and it will disconnect immediately after releasing the finger
fingerprint module:S3
standard storage capacity:500
Colour:As Shown
Material:plastic+metal

Package Contents:
1 * Control board + shell
1 * fingerprint module

Only the above package content, other products are not included.
Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.