Car Dent Repair Kit Without Paint Removal

- Easy to use, it helps you quickly and easily restore minor to moderate dents without damaging the original paint. - Saves money. - The kit includes three different sizes of sheet metal pullers. - Suitable for different dent sizes. - Suitable for car surfaces, refrigerators, washing machines, and all flat and concave metal surfaces.

How to Use:
1. Clean the damaged area with a clean, damp cloth.

2. Place the hot glue rod on the back of the hot glue gun, pull the trigger, and allow the glue rod to enter the glue gun. Then, connect the gun to the power supply and let it heat up for 5 minutes.

3. Find a suitable traction gasket (large indentation requires a large traction gasket;(note: the larger the traction gasket, the greater the traction tension);

4. Pull the trigger of the glue gun and use the extruded glue to coat the selected traction gasket (the four holes of the gasket shall also be coated with hot melt adhesive)

5. Quickly place the traction gasket coated with hot melt adhesive on the central part of the dent and gently press it down until the hot melt adhesive solidified and stuck firmly;(let the hot melt glue dry for about 8 minutes;We suggest that the hot melt adhesive should not be allowed to dry for more than 10 minutes.

6. Align the hole in the middle of the traction tension bridge with the fixed traction gasket bar, and put the screw rotary button sleeve on the traction gasket bar, and slowly tighten it until the dent part is pulled to the same level with the surrounding surface

7, some indentation, may need to repeat the above steps several times, in order to repair the indentation

8. If the repaired surface is raised a little, please follow the following steps: first, rub the raised point with your thumb back and forth until the raised point is as flat as other surfaces;If you can't get the bump back to level off with your thumb, tap the bump gently with a percussion stick (the position of holding the pen) until the bump comes back to level off. Sometimes, it may take several repetitions (note: when using a percussion stick, do not use too much force).

9. After the dent repair, unscrew the screw rotary button, remove the traction tension bridge, and then remove the traction gasket, if there is hot melt adhesive on the surface of the car, let the hand gently tear it off .